Mammoth Cutting Board

$175.00

2 Sessions – 2 Hours Each Session

You only need to purchase Session 1. By doing so, you will automatically be enrolled for Session 2 on the same day of the following week.

Session 1 -You will use the miter saw, planer, jointer, and table saw to cut a few strips of walnut. Once you experience this process you will then put together your board, roughly 15″x22″x1.25″.  After you are happy with your design you will glue and clamp your board together.

Session 2 – Now that the glue is dry we will use the planer to reveal your beautiful board and then trim it up on the miter saw. You can choose how you want your edges finished and add a juice groove if you’d like. Then we will be ready to sand. With our festool sanders you will have your board sanded to perfection in no time. Finally, we use Walrus cutting board oil to finish off your board, and even add a layer of Walrus wax if you want it to add water protection for you beautiful piece.

Important class information:

    • No experience required
    • Class size limited to 6
    • Laser engraving not included
    • Please no loose fitting clothes, dangling jewelry, long sleeves that cannot be pushed up and tie back long hair

Address

5000 Goodman Drive,
Unit 101
Timnath, CO 80547

Contact

(970) 691-2144

mail@makers-bench.com

Hours

By appointment during these hours:

Tues-Thurs: 10 a.m. - 3 p.m.
Fri: 10 a.m - 7 p.m
Sat: 10 a.m. - 6 p.m.
Sun: 10 a.m. - 4 p.m